Catalog
Romãnä

Ecran retroproiecție

Rimini (Italy)

The management of Rimini Fiera decides to divide the space of one of its pavilions with a large Ecran retroproiecţie .After carrying out the load-bearing tests, the screen will weigh 380 kg, to hang it it is decided to use the arched tie beam of one of the trusses that support the roof of the pavilion ...
Vezi toate
... so the upper edge of the screen will be shaped like an arch.12 4B - Tackle blocks 4B-400 are fixed to the beam of the truss, whose central point is 15 m high, which ...
... once the screen has been arranged on the floor under the truss ...
... will allow it to be hoisted easily, and without the risk of damaging it, by means of the 3E - Frânghie Poly Ø 10 mm.of the Stangi manuale.The upper edge of the screen was finished with Chinga, Capse and Bride, while in the lower pocket ...
... a 5 cm Ø and 60 m long ballast Tub aluminiu has been inserted.The Ecran retroproiecţie, which was made of RNV - Nevada film, is ready to receive the projections ...
... which will be performed in edge blending with 10 projectors, due to the large surface of the screen (about 720 m²) and the limited space available behind it.
The screen will be used on countless occasions and will be hung, when necessary ...
... to the tie beams of other trusses, thus allowing the space to be adapted ...
Large RNV - Nevada Ecran retroproiecţie made for one of the exhibition pavilions of Rimini Fiera.
It is 60 m wide, 15 m high at its center and it weighs approximately 380 kg.
It is installed at the beginning of the events in which it is used and is dismantled at their end.

Materiale utilizate în această producție

3E - Frânghie Poly

Franghii

4B - Tackle blocks

Role

Ecrane retroproiecție

Ecrane pentru retroproiecție

RNV - Nevada

Folii retroproiecție

Stangi manuale

Sisteme de stangi

Tevi

Stangi pentru scenotehnică

Informatii despre prelucrarea datelor
Privacy PolicyCookie PolicySetari