Catalogue
English

Rear-projection screen

Rimini (Italy)

The management of Rimini Fiera decides to divide the space of one of its pavilions with a large Rear-projection screen .After carrying out the load-bearing tests, the screen will weigh 380 kg, to hang it it is decided to use the arched tie beam of one of the trusses that support the roof of the pavilion ...
View all
... so the upper edge of the screen will be shaped like an arch.12 4B - Tackle blocks 4B-400 are fixed to the beam of the truss, whose central point is 15 m high, which ...
... once the screen has been arranged on the floor under the truss ...
... will allow it to be hoisted easily, and without the risk of damaging it, by means of the 3E - Poly rope Ø 10 mm.of the Manual fly lines.The upper edge of the screen was finished with Strap, Eyelets and Ties, while in the lower pocket ...
... a 5 cm Ø and 60 m long ballast Aluminum tube has been inserted.The Rear-projection screen, which was made of RNV - Nevada film, is ready to receive the projections ...
... which will be performed in edge blending with 10 projectors, due to the large surface of the screen (about 720 m²) and the limited space available behind it.
The screen will be used on countless occasions and will be hung, when necessary ...
... to the tie beams of other trusses, thus allowing the space to be adapted ...
Large RNV - Nevada Rear-projection screen made for one of the exhibition pavilions of Rimini Fiera.
It is 60 m wide, 15 m high at its center and it weighs approximately 380 kg.
It is installed at the beginning of the events in which it is used and is dismantled at their end.

Materials used in this production

3E - Poly Rope

Ropes

4B - Tackle blocks

Pulleys

Manual fly lines

Fly facilities

Rear-projection screens

Rear-projection screens

RNV - Nevada

Rear-projection films

Top battens and tubes

Bars for stagecraft

Information on data processing
Privacy PolicyCookie PolicySettings