Top battens and tubes

The Tubes for stagecraft with a round section are used to make the Top battens and the Ballast tubes.
The Top battens are bars for hanging light loads, such as borders, wings, light backdrops and screens.
They can be secured to the bearing structures with various accessories, including the 8C50 - Clamp Ø 50 mm + M8 nut.
If movable to be lifted by Manual fly lines, they are supported by textile ropes usually tied with clove hitches.
The distance between the fixing points depends on the load and does not exceed 3 m.
Top battens of various lengths can be made by joining the segments with their connectors, normally without exceeding 12 m, in which case they require at least 5 suspension points.
The Tubes for stagecraft are also used for the Ballast tubes to be inserted in the bottom pocket of backdrops and screens, these too to be joined with connectors, with no length limits because they are supported by the backdrops themselves.
Upon request, the Tubes for stagecraft can be curved and enamelled.

---

---

---

---