Каталог
Русский

ZHM - Зеркала из QHM - Holofilm

 

Призрак Пеппера или Pepper's Ghost.B. ZHM - Голографическое ЗеркалоC. Реальные субъекты1. Локальная подсветка актера3. Отраженное изображениеZ. Результат глазами зрителя
Посмотреть все
Призрак Пеппера или Pepper's Ghost.A. Экран для фронтальной проекцииB. ZHM - Голографическое ЗеркалоC. Реальные субъекты1. Локальная подсветка актера2. Прямая проекция3. Отраженное изображениеZ. Результат глазами зрителя
Призрак Пеппера или Pepper's Ghost.A. Экран для фронтальной проекции или Экран обратной проекцииB. ZHM - Голографическое ЗеркалоC. Реальные субъекты1. Локальная подсветка актера2. Прямая проекция3. Отраженное изображениеZ. Результат глазами зрителя
One of the greatest football players in history is filmed as he recalls his career in the '60s, in one of the most prestigious clubs in Europe.
In a section of the museum of the football club, the video is reflected in a ZHM - Голографическое Зеркало.The footballer tells as if he were present, while behind him you can see the trophies and the videos of historic matches.
The ZHM - Голографическое Зеркало, 3 m wide and 3,3 m high, is installed with an angle of 45° ...
... and it reflects a video that is projected horizontally on the ceiling.
Призрак Пеппера или Pepper's Ghost.B. ZHM - Голографическое ЗеркалоC. Реальные субъекты1. Локальная подсветка актера3. Отраженное изображениеZ. Результат глазами зрителя
It is a transparent mirror for the holographic reflection of a video projected on other surfaces (Экраны обратной проекции, Экраны для фронтальной проекции, monitors) or of real subjects, allows the superimposition of the reflected image on a real background with a three-dimensional effect.

The adjustment of the brightness of the video reflected from 0 to 100% and vice versa allows to display or hide the reflected subject (hologram).
The effect is also known as the Призрак Пеппера или Pepper's Ghost and was described for the first time by Giovanni Battista Della Porta in 1584 and subsequently by Атаназиуса Кирхера.

The transparent QHM - Holofilm with which it is made prevents the duplication of the reflected image that would be obtained with the use of sheets of glass or plexiglass.

The holographic image is not obtained with a direct projection on the ZHM - Голографическое Зеркало but with the reflection and the projection, therefore, does not reach any of the zones that can be watched.
Смотрите
QHM - Holofilm прозрачный, ширина 393 см

Зеркало
натягивается на
1 - раму из Алюминиевые фермыchâssis
2 - 9TM - Рама для сценографии, изготовленную на заказ
The flexion of the frame has to be imperceptible or it won't be possible to adequately stretch the mirror that will show folds and deformations of the reflected image.
The mirrors have to be stretched along the four sides in a uniform way.

Perimeter
and dimensions
of the mirror
1 - WCS - Строп + WOC - Люверсы + WPE - Perofix 27 cm
In this case the mirror must have a size of 5 cm per each side less then the inside area of the frame to allow the correct stretching of the WPE - Perofix 27 cm.
It is needed a perimetric masking, whose dimensions have to be of 20 cm per side less than the inside area of the frame, in order to hide the creases due to the punctual tension of the elastic hooks on the eyelets.
2 - карман + 8FV - Стеклянный Прут Волокна + WCG - Krik straps
For experienced users, it allows to avoid the punctual tension of the elastic hooks on the eyelets but it however needs a perimetric masking whose dimensions have to be 20 cm per side less than the inside area of the frame.

Transport
rolled up and protected by a special packaging
Storage
installation immediately after delivery is higly recommended;
prolonged rolling and temperatures not included in the +4° C / + 28° C range could damage the film
Installation
the roll packaging must be slipped or rolled out of the crate / protection box (not taken out lifting it) avoiding crushing the packaging and provoking a flexion of the roll;
the roll must be unrolled on a flat floor protected by a clean and soft cloth without dragging the film;
the dragging of the film and the flexion of the packaging tube can cause irreversible abrasions and marks;
the frame of the mirror must be fixed to the mirror while it is lying horizontally on the floor;
the frame with the mirror can be brought into a vertical position only after fixing the mirror;
the mirror film is not similar to the film of a vinyl screen, if it is inadvertently bent or scratched the damage is irreversible;
for those reasons the mirror surface is scrupulously inspected before packing
Maintenance
dust can be removed with an anti-electrostatic feather duster;
fingerprints can be removed with a very soft cloth like those used for cleaning the lenses of glasses

Видео и документация

Фестиваль Равенна, ''Pietra di diaspro''

Этот материал использовался для...

Фестиваль Равенна, ''Pietra di diaspro''

Опера

QHM - Holofilm

Зеркальные материалы

Robin & R.J. Gibb, ''Titanic Live Concert''

Концерты